Energy UNITS FOR LIFT TABLE 1
General Description
This energy unit is intended exclusively to the compact lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be extensively employed from the market of logistic products for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed by the solenoid valve using the velocity managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This electrical power unit is designed solely for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve along with the pace managed through the adjustable needle valve. When the lift rises to a large positoin, however the electrical power supply is reduce, the decreasing motion is managed from the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is built solely to the substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, 
tank, ect. The decreasing motion is actived from the solenoid valve as well as the velocity controlled by a stress compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is intended solely to the significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve and also the speed controlled through the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is minimize, the reducing movement is controlled through the manual override function.
Specific Notes
1. This power unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic elements concerned ahead of installation of the electrical power unit.
three. Viscosity of your oil shoud be 15~46 cst,which should really also be clean and no cost of impurities.N46 hydraulic oil is encouraged.
4. Oil transforming is required after the initial a hundred operation hours,afterwards once just about every 3000 hours.
5. The electrical power unit proven is intended to be mounted vertically.
